300Lt - 500 Lt - 1000 Lt - 1500 Lt - 2000 Lt
Completely made of AISI 304 quality stainless steel
1st walla base is 2mm and 0,8 mm Ep type heat transfer plate is coupled with wall
1st walla body is 1,5 mm
Isolation wall is 1mm AISI 304 quality stainless steel
1 piece 25 W 25 rpm gearbox and stainless steel agitator coupled with gearbox. Agitator is designed according to milk structure protection
Product Outlet DN 50 male union butterfly valve
Insulation material; HCFC free water based high density polyurethane foam and isolation thickness is 60 mm.
Spring cover system and Ø 200 mm product inlet.
Special manual scale with 3-4 ‰ sensitivity rate
Designed to leave 0 liquid in the tank after discharge
Tank body coupled on whole chassis
Welding; Argon Tig welding system applied and welded areas are 1 st class smoothly polished
Cooling evaporator (rollbond) is tested against 40 bar test pressure.
Min. gas charge ability
A 404 gas cooling
Cooling possibility in min. milk quantities without icing.
Milking refrigeration time from 35 °C to 4 °C under 3 hours in 38 °C – 43 °C environmental temperature. Compliance test reports can be seen for each of our tanks.
Drier, sight glass, expansion valve, selenoid valve, liquid protector and valves etc. exist for each cooling compressor.
Cooling compressors are coupled on chassis.
Electronic Control Panel
Electoronic Control system works by electronic KROMEL cards and it's coupled with stainless steel frame board.
Working principle of tank, Milk Temperature are controlled by control panel.
Phase protection relay
When the cover is opened system (reducer and cooling) is automatically disabled.
Thanks to special automatic agitator software; when the milk temperature reaches set value the operating range of the agitator can be adjusted. ( i.e works for 3 minutes and stops for 10 minutes)
Electrical system is Protection Grade IP 65 conforming to the European standards.
Digital Level Indicator
0- ‰ 2 measuring accuracy
The amount of milk in the tank can be monitored from the control panel
The amount of milk in the tank can be monitored both in mm and it parameters
Heat Regeneration Tank