Horizontal Type Milk Cooling Tank

Product Code: MilkCooling-006

GENERAL DATA
AISI 304 quality stainless steel
There is a cooler evaporator surface of 1.0 mm Ep type laser welded with a 1. 2 mm dowel base and coupled to the wall.
The isolated vessel is 2 mm in 5000 lt - 12000 lt capacity tanks.
The cooling unit and the tank body are mounted on a single frame.
In 6000-12000 lt tanks there are 2 0.34hp 33d / d reducer and stainless steel mixer connected to it.
The insulation is 60 mm thick and is insulated with HCFC-free water-based high den Styrofoam foam material.
Product outlet DN 50 is the male record butterfly valve.
On top AISI 304 quality stainless steel Ø 500 mm manhole cover is available.
There is a Ø 100 mm product entry on the manhole cover.
There is a Ø 90 ventilation grille on the top.
There is a manual measurement chart with a calculation table with a sensitivity ratio of 3% to 4%.
It is AISI 304 quality ladder which prevents slipping.
Design in the form of zero fluid during discharge.
Welded areas are 1st class Argon TIG welder and 1st class smooth polished.
Adjustable foot bolts are available on the scaffold.
Cooling Group
Fast and freezing freezing according to minimum amount of milk
Minimum amount of gas charge
A 404 gas cooled
Milk Cooling Tanks allow cooling of each milking (32 ° C - 38 ° C) to ambient temperature of 35 ° C to 4 ° C.
The compressor has a selonoid valve, expansion valve, dryer, sight glass, liquid holder and valves.
Direct cooling system
Certificate of conformity to TSE 13732 standard
Optional 2 l, 4 l, 6 l milking system design
Electric Group
IP 65 Electrical panels with protection class
Working with 380 volts energy
Heat indicator with digital thermometer
Special design, easy to use electronic control card to operate the tank, milk temperature, electronic milk measurement, washing system and menus are controlled.
In the event of an electronic system failure, cooling can be continued by taking it to the manual position.
There is an additional electromechanical safety system set to 1.5 - 2ºC to prevent freezing of the tobacco.
It gives an error message about the fault that occurs in case of any fault.
In order to prevent sudden current draw in multi-system compressors, the compressors are gradually activated.
In the last 20 days, there is a possibility to see defects, wash temperature, milk temperature, electricity failures.
Phase protection relay
Automatic software mixing program with special software; Once the milk has reached the desired setpoint, the agitator run time can be set at desired intervals. (3 minutes running and 10 minutes stopping)
Digital Level Indicator
‰ Possibility to make measurement with error margin of 0-2.
The amount of milk in the tank can be monitored from the control panel.
The amount of milk in the tank can be shown in mm, kg, and lt.